Water vapour characteristics and radiative effects at high-altitude Himalayan sites
by U.C Dumka, D.G Kaskaoutis, Pradeep Khatri, Shantikumar S. Ningombam, Rahul Sheoran, Sridevi Jade, T. S. Shrungeshwara, Maheswar Rupakheti
We analyze long-term aerosol and precipitable water vapour (PWV) properties at two high-altitude sites (Nainital and Hanle) over the central Himalayan and western Trans-Himalayan region from 2008 to 2018. First-time assessment of the seasonality and variation in combined aerosol and water vapour radiative effects are also attempted, aiming to investigate the atmospheric effect on solar radiation over the Himalayan range that is especially important for the regional climate. A synergy of ground-based measurements from sun photometers, GPS (Global Positioning Systems) observations, radiosondes, along with satellite and reanalysis data was used to examine inter-annual and seasonal variability of PWV and specific humidity over both sites. The PWV is highest in monsoon and much lower during the dry winter season with slightly higher values at Nainital compared to Hanle. This is due to the lower altitude (∼2 km amsl) of Nainital, which is also directly affected by the Indian summer monsoon, compared to the Trans-Himalayan region. The vertical profiles of PWV from satellite and reanalysis data reveal a great consistency on a seasonal basis. The PWV is considered as one of the main greenhouse gases that exhibits a positive radiative effect at the Top of the Atmosphere (TOA) in the order of about 10 W m−2 at Nainital and 7.4 W m−2 at Hanle. The atmospheric radiative effect due to water vapour is about 3–4 times higher compared to aerosols, resulting in atmospheric heating rates of 0.94 and 0.96 K Day−1 at Nainital and Hanle, respectively. The results highlight the importance of water vapour and aerosol radiative effects in the climate sensitive Himalayan range.
Evaluation of long-term variability of ionospheric total electron content from IRI-2016 model over the Indian sub-continent with a latitudinal chain of dual-frequency geodetic GPS observations during 2002 to 2019
by Siva Sai KumarRajana, T.S.Shrungeshwara, Chiranjeevi G.Vivek, Sampad Kumar Panda and Sridevi Jade
We evaluate the performance of the latest version of International Reference Ionosphere (IRI-2016) by comparing the estimated Total Electron Content (TEC) with the observed values from four geodetic Global Positioning System (GPS) receivers, latitudinally aligned from the equator to low latitudes (−5° to 20° Geomagnetic) in the Indian longitudes (75–95°) from 2002 to 2019. It is observed that IRI-2016 model underestimates and overestimates the GPS TEC depending on the season, solar activity, and geographic location of observation. On a decadal scale, the monthly mean of IRI TEC and GPS TEC show distinct seasonal variation trends for all years with seasonal asymmetry. The bias and RMSE values are low in the ascending and descending phases of solar cycles 23 and 24 compared to high values with significant fluctuations observed during the peak solar activity phase. For the declining phase of solar cycle 24, IRI TEC underestimates the GPS TEC values at EIA crest regions. On an annual scale, IRI TEC agrees better with GPS TEC during the low solar activity years (2010 and 2019) than the high solar activity years (2002 and 2014). Moreover, IRI model is unable to manifest the winter anomaly characteristics during the high solar activity years. On a diurnal scale, the performance of IRI model is poor with high RMSE during daytime hours and it underestimates the GPS TEC at equatorial and low latitude regions during the high solar activity phases. On a seasonal scale, high bias and RMSE are observed during the spring equinox compared to other seasons under the high solar activity phases. On a spatial scale, the bias and RMSE are high with low yearly coefficient of determination () in the EIA crest regions as compared to the equatorial and low latitude regions. High underestimation of IRI model was also observed in November 2011 due to high solar indices. The proportionality relationship between RMSE and solar indices is observed in all the phases of solar activity. Additionally, the mean annual RMSE and values indicate solar activity predominantly affecting the performance of IRI model. This study suggests that the influence of solar and magnetic indices inputs in the present IRI model could be revisited for reflecting the solar activity effects distinctly in the model outputs. In addition, IRI-2016 model requires further improvements for equatorial, low latitude, and EIA crest regions of the Indian sub-continent, specifically during the high solar activity phases.
Source: https://doi.org/10.1016/j.asr.2021.12.005
Imaging subsurface geological complexity (2D/3D) beneath the Greater Srinagar region of the Kashmir basin, Northwest Himalaya
by S. Vishal Gupta, Imtiyaz A. Parvez and Prosanta K. Khan
A high-resolution microtremor measurement in Greater Srinagar city of the Kashmir valley has been analysed to image 2D and 3D subsurface geological complexities. This region is located in the highly seismogenic Himalayan belt and sits atop a deep sedimentary lake bed with a laterally varying thickness of soft sediments. Srinagar region is a major economic centre and the capital city of the Kashmir valley with 2 million inhabitants living at high seismic risk. To assess the subsurface complexity beneath the city, we present: (1) high-resolution subsurface shear wave velocity Vs structure using the horizontal-to-vertical spectral ratio inversion; (2) shear wave velocity for top 30 metres of soil column (VS30) map with National Earthquake Hazards Reduction Program site classification; (3) comparison of VS30 maps calculated from horizontal-to-vertical spectral ratio inversion and topographic slope methods; and (4) azimuthal behaviour of horizontal-to-vertical spectral ratio peaks, all of which unravel the subsurface spatial heterogeneity and suitability for the building of engineering structures in the study area. In addition, a new matlab code is applied to generate 3D subsurface Vs slices in the study region in different directions using its pre-generated 2D Vs profile data. The presented potentiality of microtremor horizontal-to-vertical spectral ratio technique in Srinagar region, which lies on the eastern edge of the basin with significant topographic irregularities, indicates an uneven distribution of local site effects (primary and secondary) in the case of strong ground motion. The comprehensive results can be promising in engineering analyses of local ground and structural responses in order to mitigate the impact of earthquake occurrence and seismic risk in the city and adjoining regions.
Source: https://doi.org/10.1002/nsg.12186
Detecting aliasing and artifact free co-seismic and tsunamigenic ionospheric perturbations using GPS
by M.Sithartha Muthu Vijayan and K.Shimna
Ionospheric perturbations induced by tsunamis and earthquakes can be used for tsunami early warning and remote sensing of earthquakes, provided the perturbations are characterized properly to distinguish them from the ones caused by other sources. The ionospheric perturbations are increasingly being obtained from Global Positioning System (GPS) based Total Electron Content (TEC) measurements sampled at uniform time intervals. However, the sampling is not uniform in space. The nonuniform spatial sampling along the GPS satellite tracks introduces aliasing if it is not accounted while computing the ionospheric perturbations. All the methods hitherto used to detect the co-seismic and tsunamigenic ionospheric perturbations did not account the nonuniform spatial sampling while computing these perturbations. In addition, the residual approach used to obtain the perturbations by detrending the TEC time series using high-order polynomial fit introduces artifacts. These aliasing and artifacts corrupt amplitude, Signal-to-Noise Ratio (SNR), phase, and frequency of ionospheric perturbations which are vital to distinguish the perturbations induced by tsunamis and earthquakes from the rest. We show that Spatio-Periodic Leveling Algorithm (SPLA) successfully removes such aliasing and artifacts. The efficiency of SPLA in removing the aliases and artifacts is validated under two simulated scenarios, and using GPS observations carried out during two natural disasters – the 2004 Indian Ocean tsunami and the 2015 Nepal-Gorkha earthquake. We, further, studied the severity of aliasing and artifacts on co-seismic and tsunamigenic perturbations by analyzing its characteristics employing SNR, spatiotemporal, and wavelet analyses. The results reveal that removal of aliasing and artifacts using SPLA i) increases the SNR up to ∼149% compared to the residual method and ∼39% compared to the differential method, ii) distinctly resolves signals from sharp static variations, and iii) detects 50% more co-seismic ionospheric perturbations and 25% more tsunami-induced ionospheric perturbations in the two events studied. Cross-correlation of the perturbation time series obtained using the residual method and SPLA reveals that aliasing and artifacts shift the time of occurrence by −7.64 minutes to +4.21 minutes. Further, the results show that the SPLA efficiently detects the ionospheric perturbations at low elevation angles, thereby removes the need of applying elevation cut-off and increases the area of ionospheric exploration of a GPS receiver.
Temperature-duration-frequency analysis over Delhi and Bengaluru city in India
by Rani Devi, K. C. Gouda & S. Lenka
The extreme temperature events are a concern in recent years due to climate variability particularly in India as there is an increase in the temperature intensity, frequency, and duration. This study represents stationary temperature-duration-frequency (TDF) analysis over two mega cities in India Delhi (north) and Bengaluru (south) using the daily maximum temperatures at meteorological stations for the period 1969–2016 observed by India Meteorological Department (IMD).The interannual variability of maximum temperature and the maximum daily recorded value indicates the increasing trend in both the cities. The study investigates the extreme analysis of the maximum temperature using two distributions, i.e., Gumbel’s Extreme Value Type 1 (GEVT) and Log Pearson Type III (LPT), for return periods 2, 5, 10, 25, 50, and 100 years at both the locations and the positive temporal trend is observed. The TDF curves were build using annual maximum temperature values for total 8 durations (different days) of 48 years analyzed and results show the increasing trend of maximum temperature at lower duration and high return period values. The TDF is also used for prediction of the maximum temperature for the 2 hottest years in India, i.e., 2012 and 2015, and it is comparable with the observed maximum temperature. Similarly, the predictions for 11 years, i.e. 2006 to 2016, over both the cities are simulated using both the GEVT-I and LPT-III and the models have better potential skill in predicting the extreme maximum temperature. These results can be useful for the sectors like health, energy, agriculture, urban management, and ecology management and can help the policy decision makers and disaster managers in the mitigation and adoption steps to face the extreme temperature disaster at city scale.
- Application of neo-deterministic seismic hazard assessment to India
- Sinking Slab Stress and Seismo-Tectonics of the Indo-Burmese Arc: A Reappraisal
- On the Semidiurnal Variation in Surface Rainfall Rate over the Tropics in a Global Cloud-Resolving Model Simulation and Satellite Observations
- Do seasonal forecasts of Indian summer monsoon rainfall show better skill with February initial conditions?
Page 17 of 27
